Index of /pages/GordonCouger/stuff/68hc11/NewMicro/D/4TH/MAX/

NEW MICROS, INC. 1600 CHALK HILL RD. DALLAS, TX. 75212 PH: 214 339-2204 FAX: 214 339-1585 BBS: 214 339-2321 2400,8,N,1 NMI UTILITIES DISK - MOST FILES ARE ZIPPED ON THIS DISK TO KEEP THE SIZE UNDER 1.2M. TO UNZIP: 1. Copy disk to hard drive or larger disk, go to directory to unzip, and type PKUNZIP *.ZIP 2. Or create a directory on your hard disk for the files, go to that directory, and type PKUNZIP A:\xxxxx\*.zip. xxxxx is the name of the directory on the utilities disk that you want to unzip. DISK CONTENTS: PKUNZIP.EXE README (THIS FILE) |____ SMALLC - SMALLC.ZIP, SMALLC COMPILER AND UTILITIES |____ BASIC11 - BASIC11.ZIP, BASIC11 OBJECT CODE AND MANUAL | (NOTE: OBJECT CODE IS .S19 or .HEX RECORD AND | MUST BE PROGRAMMED INTO AN EPROM WITH | AN EPROM PROGRAMMER. |____ AS11 - AS11.ZIP, AS11 ASSEMBLER AND MANUAL |____ MAXTALK - MAXTALK.ZIP, MAXTALK PC COMMUNICATIONS | (NOTE: MAXTALK2.EXE SUPPORTS FOR COM.PORT2. |____ UMMAX - UMMAX.ZIP, MAXFORTH DOCUMENT |____ WIPE35 - WIPE35.ZIP, 68HC11 WIPE UTILITY (PC) | (NOTE: FOR NMIX/T-0020 THE JUMPERS FOR | MODA = "D" & MODB = "E". |____ NMIX20 - X0020.ZIP, X0020.TXT NMIT/X-0020 MANUAL |____ NMIX22 - X0022.ZIP, X0022.TXT NMIT/X-0022 MANUAL |____ BUFFALO - BUFFALO.ZIP, MOTOROLA BUFFALO OBJECT CODE (NOTE: OBJECT CODE IS .S19 OR .HEX RECORD AND MUST BE PROGRAMMED INTO 27C64 WITH EPROM PROGRAMMER. Please note that the BASIC11 and BUFFALO are Motorola "S" record or hex files of object code and must be programmed into a 27C64 EPROM or larger with an access time of 200ns or faster. Following is the procedure to operate the NMIT-0020 using BASIC11 or the BUFFALO monitor: 1. Send BASIC11.S19 or BUFFALO.S19 file to your EPROM Programmer. 2. Program EPROM. (Note: If a larger Eprom than 27C64 is used, an offset must be added so that the 8K of code will program at the top of the Eprom's addressable area. ie: For 27c256, Offset = + $6000 hex.) 3. Run WIPE35 on the NMIT-0020: Disable Internal Rom (Forth) 4. Install Basic11 or Buffalo Eprom in Right memory socket (U4) 5. Verify U4 memory socket option straps are correct 6. Basic11 or Buffalo prompt should appear on serial port at 9600 baud after Reset.